We now make hackles!<\/p>\n
After quite a few requests for them we have found some space to build them. I am really pleased with how they turned out. We have again used Baz’s great idea of bonding the pins into the hackle base using resin – it makes all the pins perfectly straight and aligned. They have an excellent cover to go over the pins so nothing gets pricked unnecessarily :-). I am also very pleased with the new clamps we have made for the hackle. Using our ‘Selection of Cleverness’ again, we did things like drill the holes as slight angles so the hackle is held more firmly onto tables. The clamp block is covered with rubber that helps hold the hackle tighter while protecting your table. The hackle has tiny rubber feet for the same reason.<\/p>\n You might also notice the steps at the end of the hackle. They have been provided as a place to clamp the hackle with ‘F’ clamps if you prefer these to the Majacraft ones. As a nice little finishing touch, we laser engraved Majacraft on to the hackle base.<\/p>\n![\"Double](\"https:\/\/www.majacraft.co.nz\/wp-content\/uploads\/hackle_set_med.jpg\" "\\"Double")
<\/a>